| Indicator | Color | Status Meaning | | :--- | :--- | :--- | | | Green | Control box powered. | | ERR | Red | Fault detected (overcurrent/overvoltage). | | RUN | Blue | Motor receiving pulse signal. | | UP | Yellow | Needle at top dead center. |
| Pin | Signal | Function | | :--- | :--- | :--- | | 1 | GND | Signal ground | | 2 | +5V | Encoder power | | 3 | A+ | Encoder channel A | | 4 | B+ | Encoder channel B | | 5 | P1 | Foot pedal (wiper) | | 6 | P2 | Foot pedal (trim signal) | | 7 | SOL+ | Trimmer solenoid (24V) | | 8 | SOL- | Solenoid return | | 9 | SW1 | Safety switch (presser foot) | | 10 | SW2 | Pedal neutral detection |
Note: Pinouts for the 5-pin motor power connector are labeled U, V, W, GND, and Brake. To access parameters, press and hold P for 3 seconds while the machine is stopped. Use the + / - buttons to navigate.
| Indicator | Color | Status Meaning | | :--- | :--- | :--- | | | Green | Control box powered. | | ERR | Red | Fault detected (overcurrent/overvoltage). | | RUN | Blue | Motor receiving pulse signal. | | UP | Yellow | Needle at top dead center. |
| Pin | Signal | Function | | :--- | :--- | :--- | | 1 | GND | Signal ground | | 2 | +5V | Encoder power | | 3 | A+ | Encoder channel A | | 4 | B+ | Encoder channel B | | 5 | P1 | Foot pedal (wiper) | | 6 | P2 | Foot pedal (trim signal) | | 7 | SOL+ | Trimmer solenoid (24V) | | 8 | SOL- | Solenoid return | | 9 | SW1 | Safety switch (presser foot) | | 10 | SW2 | Pedal neutral detection | | Indicator | Color | Status Meaning |
Note: Pinouts for the 5-pin motor power connector are labeled U, V, W, GND, and Brake. To access parameters, press and hold P for 3 seconds while the machine is stopped. Use the + / - buttons to navigate. | | UP | Yellow | Needle at top dead center