| Parameter | Description | Typical Range | Tuning Guide | | :--- | :--- | :--- | :--- | | | Position loop gain | 20-300 rad/s | Higher = more responsive. Start at 30. Increase gradually. | | SV002 | Speed loop gain | 20-1000 rad/s | Set ~2-4x position gain. | | SV003 | Speed loop integral time constant | 10-200 ms | Lower = stiffer. 40-80 typical. | | SV004 | Feedforward gain | 0-100% | 0% = no FF. 30-70% reduces following error. | | SV006 | Torque filter time constant | 0-2500 µs | Reduces noise. 100-500 typical. | | SV012 | Load inertia ratio | 1-2000% | Critical for performance. Use auto-tuning first. | | SV031 | Overshoot detection level | 0-200% | 100% typical. Reduce to 50% for safety. | | SV083 | Motor series code | (Read only) | Verify matches actual motor type. | C. Spindle Parameters (SP) (#3000 - #3999) | Parameter | Description | Notes | | :--- | :--- | :--- | | SP004 | Spindle max speed | In min⁻¹ (RPM). | | SP006-009 | Gear selection method | 0 = M41-M44, 1 = auto gear range. | | SP018-021 | Gear ratio numerator (each gear) | Example: 1:1 → 1. 2:1 → 2. | | SP022-025 | Gear ratio denominator | Example: 1:1 → 1. 2:1 → 1. | | SP041 | Orientation stop position | In degrees (0-359.999). | | SP083 | Spindle motor series code | Must match actual spindle motor. | | SP117 | Rigid tapping (0=off, 1=on) | Requires option hardware. | D. Option Parameters (#6000 - #6999) These enable hardware/software options. Requires manufacturer password.
| Type | Address Range | Purpose | Example | | :--- | :--- | :--- | :--- | | | K0 – K999 | On/off machine logic settings | K5.0 = 1 enables automatic lubrication | | Timers (T) | T0 – T999 | Time delays (ms or 10ms) | T10 = 500 → 5 sec delay | | Counters (C) | C0 – C999 | Count events | C25 = 100 → tool change count | Mitsubishi Meldas 64 Parameter Manual
| Parameter | Bits | Function | | :--- | :--- | :--- | | | bit 0 | AICC (Advanced High Precision Contouring) – enables G05.1 | | #6101 | bit 1 | High-speed machining mode | | #6102 | bit 0 | Rigid tapping enable | | #6105 | bit 4 | Spindle synchronization (e.g., for dual spindles) | | #6201 | bits 0-3 | Max controlled axes (4,5, etc.) | 4. PLC Parameters (Keep Relays, Timers, Counters) Access: DIAGN/IN/OUT → PLC → KEEP / TIMER / COUNTER | Parameter | Description | Typical Range |