(A step‑by‑step manual for getting the most out of your custom‑shaped, high‑performance gaming mouse) 1️⃣ Quick‑Start Overview | What | Why | How | |------|-----|-----| | Unbox & Inspect | Verify all components are present and undamaged. | Remove the mouse, cable, USB‑CCS adapter, quick‑start guide, and optional magnetic wrist‑rest. | | Connect | Power the mouse and enable its custom firmware. | Plug the detachable USB‑C cable into the mouse and a USB‑A/‑C port (use the supplied USB‑CCS adapter for older PCs). | | Install Software | Access DPI, lighting, macro, and sensor tuning. | Download Siberian‑Mouse‑Config v2.3+ from the 1st Studio support portal. | | Calibrate | Achieve optimal tracking for your surface. | Run the built‑in sensor calibration wizard (Settings → Sensor → Calibrate). | | Save Profile | Keep your settings across machines. | Export to a .smm file or sync to the cloud (requires a free 1st Studio account). |
Export your finished profile ( File → Export → .smm ) and keep a backup on a USB stick or cloud drive. 5️⃣ Advanced Customizations 5.1 Sensor Tuning for Different Surfaces | Surface | Recommended Settings | |---------|----------------------| | Hard‑plastic mousepad | DPI 2400‑4800, lift‑off 0.8 mm, polling 2000 Hz. | | Cloth mousepad | DPI 1200‑2400, lift‑off 1.2 mm, polling 1000 Hz. | | Glass/Glossy | Enable “Glide‑Mode” (software > Sensor > Advanced → “Smooth Track”). | | Gaming desk (wood) | DPI 800‑1600, lift‑off 1.0 mm. | -1st Studio-Siberian Mouse Custom MSH 45.avi
🚀 All specifications and software versions are current as of April 2026 . For any newer firmware releases, refer to the official 1st Studio support page. (A step‑by‑step manual for getting the most out
2 years limited. Register your serial number within 30 days to activate extended support. 7️⃣ Troubleshooting Quick‑Fixes | Symptom | Likely Cause | Fix | |---------|--------------|-----| | Cursor jumps / stutters | Surface calibration off or sensor dirty. | Re‑run calibration; clean sensor. | | Buttons not responding | Firmware glitch or profile not active. | Restart the config app; re‑assign the button; if persists, Re‑flash firmware (Software → Firmware → “Re‑install”). | | Lighting flickers | Power draw issue (cable loose). | Re‑seat USB‑C connector; try a different USB port (preferably USB‑3.0). | | Macro not triggering | Macro script error. | Open macro editor → “Validate”; fix syntax or re‑record. | | Mouse not detected | Driver not installed or USB‑C port disabled in BIOS. | Re‑install driver; enable “USB Legacy Support” in BIOS; try a different port. | | DPI switch stuck | Physical switch debris. | Gently blow air; if still stuck, contact support for replacement switch. | | Plug the detachable USB‑C cable into the